Factory Sample 1949-54 FL Rigid Rear Fender
Before you order — V-Twin tech note
- Underside of rigid rear fender details: A) Wire Loom Spring,B) Hinge Junction, C) Loom Clip Strip on Fender Radius, D) Spring Clip, E) 7/8" Wide Brace, F) Ribbed Chain Panel.
- *NOTE: Replacement fender ordered thru H-D dealer came with 3/4" brackets. These were over the counter replacements, notOEM installed at the factory.
- *NOTE: Fender tail with cut out is #50-0366.
- Suggested to use with #31-0186, Parkerized Rear Kickstand Catch
- Suggested to use with #50-1250, Wire loom Fender Strip Raw
Description
2024 New Production rear rigid fender assembly includes a segmented wire loom conduit and features an updated hinge design for the rear tail. Chain panel is ribbed and part of the fender. Assembly features a raw finish. Rigid rear fender features a three rib indent in the chain guard cut-out panel and 7/8" wide braces. 1949 rigid rear fender features a one rib indent. Wire loom provisions on underside includes replica rigid rear fender hinge, spring connector loom, and segmented tube on skirt. Assembly is for use with Tombstone tail lamps. Includes straps and u starp reveted in place.
*NOTE: Does not acceptstainless steel fender trim and clips for this year. Factory sample are brand new pre-production parts but have imperfections in the finished surface. Check threaded and bearing holes for excess plating before installation. There are no physical defects, such as cracks or holes, there will be cosmetic imperfections only. Sample parts may show marks from installation test and fitment.
*NOTE: Replacement fenders ordered through H-D dealers came with 3/4" brackets that are "over the counter" replacements, not OEM installed by the factory. Constructed with 3/4" fender brace.
Specifications
- V-Twin number
- 50-2248
- Manufacturer
- V-Twin
- Sold as
- 1 - KIT
- Origin
- Imported
- Measurements
- Strap Brace Width: 7/8"