Replica Rigid Rear Fender
You will also need another part
- Required *NOTE: We have an updated rear hinge available to replace existing hinge. Must be riveted in place, #50-1243 Replica Rigid Rear Fender Hinge.
Description
Replica rigid rear fender has 1949-1950 style chain relief cutout. Fender is fully assembled and riveted together with hinge. Before finishing with primer or paint installer must prepare fender by checking alignment of fender tail and bracket. All hinged fenders must be hand fitted at the hinge and pin area. Alignment will have to be adjusted and tweaked to fit your components. Before priming or painting, fit the fender body, braces and mounting points in place. Fender rivets, hinge and brackets will have to be tweaked for final fitment. Fender tail is not drilled or "cut out" for tail lamp installation. Patience is required for proper installation! We suggest pre-fitting fender prior to painting.
*NOTE: Chain panel with ribs is "built in" as one piece with the fender.
*NOTE: UPS may consider this part as packaged "oversize" for shipment, as compared to the actual weight, which will result in higher shipping costs.
Specifications
- V-Twin number
- 50-0744
- OEM number
- 59604-49
- Manufacturer
- Wyatt Gatling
- Sold as
- 1 - EA
- Origin
- Imported
- Measurements
- Width: 7/8"
- Style
- Stock
- 2026 catalogue pages
- 631
Goes with this part
V-Twin lists these alongside 50-0744 — replacements, the parts commonly fitted at the same time, and supersessions. Check the fitment on each before ordering.