Message us and we will send you a photo before you order.FLT Frame Hardtail Unit
You will also need another part
- Required Required to use with OEM#47540-11 Swingarm Axle, available separately.
- Required Required to use with OEM#33285-07A 6-Speed Transmission Assembly, available separately.
- Required Required to use with OEM#48487-02 Outer Swingarm Spacer, available separately. (2 needed)
- Required Required to use with OEM#48489-02 Inner Swingarm Spacer, available separately. (2 needed)
- Required Required to use with OEM#47549-09A Rear Swingarm Suspension, available separately.
Description
Frame hardtail unit is bolt in place type for initial alignment. 3 points top plate transmission mounts lower plate. Unit includes right and left side transmission mounts , upper and lower plates 2" longer than stock, tubes feature an 1-1/4" outer diameter to match existing lower frame tube. Alignment relies on the swingarm pin with bushings and upper rear frame section with 4 bolt attachment points.
*NOTE: Must order a 1" or 25mm axle separately. Axle plates are machined for a 1" axle.
*NOTE: For required OEM alignment components, refer to a FLT factory parts book.
*NOTE: Lower fender bracket installed. Top plate aligns with 3 holes in seat plate and the lower portion mounts to the transmission swingarm pin location. This hole features a 5/8" inner diameter. Lower mounts use dowel pins to drive into existing holes in lower frame rails. OEM Parts listed are for alignment purposes, and are on original chassis. OEM rear frame section is not required for alignment.
*NOTE: Primarily for installation on 2009-2016 models, but can be adapted to most Touring frames.
Specifications
- V-Twin number
- 51-1336
- Manufacturer
- V-Twin
- Sold as
- 1 - KIT
- Origin
- Imported
Goes with this part
V-Twin lists these alongside 51-1336 — replacements, the parts commonly fitted at the same time, and supersessions. Check the fitment on each before ordering.