Throttle By Wire Twist Grip Sensor
Description
Throttle by wire twist grip sensor allows installation of stock or accessory handlebars. Hardwired like OEM CVO version from the sensor to the main connection on the harness. Terminals are pre-installed. Includes 6 position connector for installation after the harness is routed through handlebars. Be sure grip is mated snugly against the gear drive to prevent damage. After installing new twist grip sensor, set the right handlebar switch to run. Turn ignition switch on, you will hear the fuel pump cycle on and off. Wait 30 seconds and turn ignition switch off. Wait for turn signals to flash for 30 seconds. Repeat this process 2 more times. This will reset the throttle body and make it in sync with new twist grip sensor.
Specifications
- V-Twin number
- 36-1885
- OEM number
- 32310-08A
- Manufacturer
- V-Twin
- Sold as
- 1 - EA
- Origin
- Imported
- Measurements
- Long Wire Length: 38"
- 2026 catalogue pages
- 155
Goes with this part
V-Twin lists these alongside 36-1885 — replacements, the parts commonly fitted at the same time, and supersessions. Check the fitment on each before ordering.